Pedal Rebound Adjust
After any adjustment, you may need to alter the pedal rebound to get the
pedal sitting nicely again. To do this, use an 8mm spanner to loosen the
locking nut (pointed out by the red arrow) then use a 3mm allen key to
adjust up or down the stop until the pedal is in your desired position. Once
you’re happy with the position, tighten the locking nut firmly.
Pedal Rebound Adjustment
If required, your pedals are fitted with an adjustable set point that can be changed using a
3mm allen key and an 8mm spanner.
ADJUSTMENTS
Pedal Set Points are adjusted via the screw stops at the base of the pedals
Accelerator Pedal Stroke Adjust
The accelerator pedal stroke can be adjusted for a
shorter stroke by rotating the alloy adjuster at the top
of the cylinder. Undo the thumbscrew on the adjuster,
rotate the adjuster to your desired position.
Once satisfied re-tighten the thumbscrew.
Once you’re totally satisfied with it’s stroke length don’t
forget to recalibrate the accelerator axis.
Please Note:
After any of these adjustments, you will need to go through the calibration process again.
