MAN.ESS-INS, Rev. E
ESS
Series Installation & Start-Up
7
SIMREX CORPORATION
It is highly recommended that the Access Point unit be installed
first.
With this plan, you can quickly check the operation of each associated
Remote as it is placed on the air.
NOTE:
Transceivers are shipped from the factory set to the “Remote”
mode unless they are marked differently.
Step 1—Mount the Transceiver
Mount the radio to a stable surface. (Fasteners/anchors or screws are
not normally supplied.) Four threaded holes are located on the bottom
of the radio that are suitable for connecting mounting hardware. Use
6-32 x 1/4 inch (6 mm) screws to attach mounting hardware to the
bottom of the radio.
Figure 1
shows the mounting dimensions.
Invisible place holder
Figure 1. Transceiver mounting dimensions
Screws used to hold the mounting brackets to the radio
case should be SAE 6-32 and should not extend farther
than 1/4 inch (6 mm) into case. This will prevent damage
to the transceiver’s internal PC board.
2.75
″
(7
cm)
7.25
″
(18.4 cm)
CAUTION
POSSIBLE
EQUIPMENT
DAMAGE
Summary of Contents for DataMover ESS Series
Page 24: ...Installation Guide...
