14
425197/B
2
Open the
Network and Sharing Center
dialog box.
a
In the bottom-left corner of your desktop, select the Windows
®
Start
button.
b
On the right-hand side of the
Start
menu, select
Control Panel
.
c
Observe that the Control Panel opens.
d
Select
Network and Sharing Center
.
(If the Control Panel is shown with categories, select
View network status and
tasks
.)
e
On the left-hand menu, select
Change adapter settings
.
f
Click once on your network adapter to select it, then right-click and select
Properties
on the shortcut menu.
g
On the list of connections, select
Internet Protocol 4 (TCP/IPv4)
, and then
Properties
.
3
Select
Use the following IP address
, and type the IP address and network mask.
•
IP address
: 157.237.15.12
(Recommended)
•
Subnet mask
: 255.255.255.0
You can leave
Subnet mask
blank and select
OK
. When you see an error message saying
that the message subnet mask is missing, select
OK
again. A default subnet mask
is then automatically generated.
4
Select
OK
to save the chosen settings, then close all the dialog boxes.
Further requirements
If you later need to change the IP address, always power cycle the WBT Mini before you
start the EK80 program.
Related topics
Using the WBT Mini in EK80 mode, page 12
Obtaining and installing the software license
To operate the WBT Mini in
EK80
mode you need a valid software license. Before you can
use the WBT Mini you must obtain a "license string" and install it on your PC. Without a
license you will not be able to communicate with the transceiver.
Prerequisites
This procedure assumes that the EK80 software has been successfully installed on the PC.
Simrad WBT Mini Instruction Manual
Summary of Contents for WBT Mini
Page 2: ......
Page 66: ... 2018 Kongsberg Maritime ...
Page 67: ......
Page 68: ...Simrad WBT Mini Miniature wideband echo sounder transceiver Instruction Manual ...