114
406388/B
Related topics
PX TrawlEye Configurator dialog box, page 229
PX MultiSensor mk2 Configurator dialog box, page 236
Main PX Sensors configuration parameters, page 264
Specific configuration parameters for PX TrawlEye sensors, page 267
Overview of sensors channels and frequencies, page 269
Configuring a PX Universal and a PX MultiCatch sensor for a SR
type receiver unit
Catch monitoring sensors are delivered from Kongsberg Maritime AS readily set up with
common default settings. When required, each individual sensor may be configured to
specify its communication channel and which measurements to make.
Prerequisites
This procedure assumes that a suitable receiver unit has been connected to the Processor
Unit, and that all relevant communication parameters have been defined.
Context
The
PX Configurator
dialog boxes allow you to set up which measurements the sensor shall
make, the communication channel and some other relevant parameters.
Depending on your hardware configuration and the type of sensor, you may configure two
measurements or up to five.
Note
The TV80only allows you to configure PX sensors. If you wish to use older sensors (not PX
family), these must be configured using their dedicated applications before you add them.
Procedure
1
Open the
Setup
menu.
2
On the
Setup
menu, select
Installation
.
Observe that the
Installation
dialog box opens.
3
At the bottom of the
Sensor list
page, select
Add New Sensor
.
The
Add New Sensor
dialog box opens.
4
Select
Yes
.
Simrad TV80 Reference Manual
Summary of Contents for TV80
