Simrad PI Geometry
• If your PI system is fitted with older software versions than
0.50, use the following recommendations:
– On the receiver, the Interference filter must be switched on.
Set it to Level
9
if you have noise problems from other
hydroacoustic sources. Note that this filters will influence
the signal spectrum shown in the
Status
display.
– We recommend that you set the sensor filter to
Light
.
Note
The Multipath filter must be set to On.
Configuration of the PI32
The PI Geometry sensor can not be used on the Simrad PI32
catch monitoring system.
Configuration of the PI44 and PI54
This procedure explains how to set up the PI44 and PI54 catch
monitoring systems to access the information provided by the
PI Geometry sensor. For more detailed information about the
settings and parameters, refer to the relevant operator and/or
reference manual(s).
Note
In order to set up the PI44 and PI54 systems, your PI operator
unit must be provided with MMI software version 0.50 or later
and digital signal processor (DSP) software version 1.11 or later.
If in doubt, check your software versions on the Status display.
We recommend that you use the form at the beginning of the
PI44 or PI54 operator and/or reference manual to write down the
sensors you have and their respective communication channels
and update rates.
Note
In order to set up the PI system you must know what kind of
sensors you have, which communication channels they use, and
how often they communicate (the update rate). You need this
information before you start the setup process.
Do not carry out sensor setup unless absolutely necessary.
18
322482/B
Summary of Contents for PI GEOMETRY
Page 2: ......
