Simrad PI Geometry
Information on the sensor identification label
The sensor PI Geometry label provides the following information.
Figure 3
The PI Geometry sensor label
A
Channel identification. You must write down the channel
currently used by the sensor to communicate with the PI
system.
B
This information identifies the sensor type.
C
Order number.
D
Water switch. This is a sacrificial bolt. The bolt will
gradually be worn out. Check it from time to time to remove
corrosion, or replace it if necessary.
The Simrad Mini-R responder
Each PI Geometry sensor needs two Mini-R responders, one on
each trawl door or wing. The two responders must be installed
with the exact same distances from the PI Geometry sensor. The
communication transducer next to the identification label on each
responder must point towards the PI Geometry sensor on the
middle of the headrope or footrope.
The two responders are fitted with labels identifying their
physical locations:
• Red colour is used for the port trawl door (or wing)
• Green colour is used for the starboard trawl door (or wing)
8
322482/B
Summary of Contents for PI GEOMETRY
Page 2: ......
