Simrad ES70
Getting started
This chapter describes how to get started with the basic operation of the ES70.
This chapter assumes that the ES70 Fish finding echo sounder has at least one frequency
channel (transceiver and transducer) readily connected. If this is not the case, observe
the dedicated procedure.
The procedure is located in the
Simrad ES70 Reference manual
.
Topics
•
on page 20
•
on page 22
•
on page 23
•
on page 33
•
on page 35
•
on page 36
•
on page 37
Power On/Off procedures
Observe these procedures to switch the Simrad ES70 on and off.
Note
Before you power up the ES70 for the very first time, observe the procedures in chapter
Installation on page 15.
Make sure that you have sufficient water below the hull before you power up the ES70 .
If you start the ES70 with the transducer in air, you may damage it beyond repair!
Power on
This procedure explains how to power up the Simrad ES70.
1
Power up the General Purpose Transceiver (GPT) unit.
(This unit is normally always powered up.)
20
343539/B
Summary of Contents for ES70 - DOWNLOAD AND INSTALLATION REV B
Page 2: ......
Page 128: ...ISBN 13 978 82 8066 118 0 2010 Kongsberg Maritime AS ...
