OPERATING INSTRUCTIONS
800-999-5099 www.strongtie.com/products/quikdrive
MAINTENANCE
As a regular maintenance procedure, we recommend that regular cleaning of the attachment be performed. Normally,
blowing compressed air on and in the attachment should be sufficient. Routine lubrication is not necessary. Do not oil.
ADJUSTING
DEPTH STOP
Proper adjustment
of profile guide
is necessary
depending on
screw size - loosen
clamp screw and
position guide
1/8" in front of the
screw point.
CLEARING JAMMED SCREWS
If a screw should become jammed in the auto-feed attachment, disengage the
power source and point the tool in a safe direction. Remove jammed screw. If
needed, depress fastener release button, firmly grasp the screw belt and pull it
out of feed track. See troubleshooting guide if problem persists.
Removal of the adjusting arm may also be necessary.
Loosen/Tighten
clamp screw to
adjust
Ensure
adjusting
arm is
1/8
"
in front
of screw
point.
Screws may
become jammed
ATTACH EXTENSION TO SCREWDRIVER MOTOR
Turn the clamping handle in the “off” direction
(clockwise) until the internal clamp is out of the way.
Insert the screwdriver motor, with G2 adaptor in place, into
the end of the extension. Push tight and tighten clamping
handle. If it won’t fully insert, rotate the extension until
the teeth mesh.
Internal
Clamp
Hex end of
extension
drive shaft
Turn thumbscrew
clockwise to
open clamp
CHANGING PROFILE GUIDES
Insert guides on nose of adjusting
arm and slide outward into place.
Reverse procedure for removal.
