Simpson 13SIE-170, Instruction Manual, Page: 20 / 42

20- ENG
OPERATIONAL
ISSuE
POSSIbLE
CAuSE
SOLUTION
No water
coming out
of nozzle
Nozzle is
clogged
Clean the nozzle according to the instructions
provided in the
Nozzle
paragraph under
Maintenance section of this manual.
Water inlet
filter screen
is clogged
Remove the filter screen (O) from the
water inlet (M) and clean it thoroughly.
Replace the filter screen.
Kink in the
garden hose
or hose is
wrapped on a
storage wheel
Use a maximum garden hose length of
50 ft. (15.2 m) (city water) or 25 ft. (7.5 m)
(well water). Ensure the garden hose is laid
out flat and does not have any kinks or leaks.
Unwrap garden hose from reel or hook (if
applicable). Replace garden hose if necessary.
Nozzle is
not installed
correctly
See
How to use Spray Wand
paragraph in the Operation Section.
No water
coming out
of nozzle
Detergent
Suction
Assembly
(the part
which the
High Pressure
Hose con-
nects to) is
malfunc-
tioning
Remove the Gun and Hose assembly from
the front of the unit. Aim water stream away
from electric source. Turn the faucet on. Water
should start to come out of the front of the unit.
If no wa ter comes out, the Detergent Suction
Assembly will have to be cleaned or replaced.
Contact our customer service department at
www.simpsoncleaning.com.
Spray Gun
Trigger will
NOT Move
Gun safety
lock is
engaged
Release safety lock according to instructions
provided in the Starting paragraph
under Operation in this manual.
Unit will
NOT start
NOTE:
Unit will
only start and
run when trigger
is depressed
and water is
spraying!
Unit is not
turned ON
Verify that the On/Off Switch (I) is
fully engaged in the ON position.
GFCI Plug
is not reset
Confirm the GFCI plug is reset and
functioning according to instructions
provided in ground-Fault Circuit Interrupter
Protection paragraph under Power
Supply & Electrical info in this manual.