User Manual
// Quikstak QS10MM
Original Instructions // English // v52.0 // April 2022 // Page
28
4.5.7
Forks
As standard, the Quikstak is fitted with two 1070x100x35mm ITA Class II forks rated to lift
1700kg at 600mm load centre. These can be removed and replaced with any ITA Class II
compliant forks or attachments if required.
The position of the forks can be adjusted to suit different pallets. The minimum fork separation
is ~200mm, and the maximum fork separation is ~765mm.
4.5.7.1
Adjusting the fork position
Observe the following procedure to adjust the position of the Quikstak forks:
1.
Withdraw the fork
’s
lock-pin from the mounting rail, and rotate it 180 degrees to
prevent it from re-locking.
2.
Slide the fork along the mounting rail to the desired position.
3.
Rotate the lock-pin to its original position, and slide the fork further in either direction
until the pin locks into one of the notches in the mounting rail.
The forks can also be removed altogether to minimise volume for shipping.
4.6
Drive & Mechanical Systems
4.6.1
Drive motor
The Quikstak is fitted with an 0.65kW DC electric motor delivering power to the drive wheel
through a gearbox (
). The motor is controlled by a Curtis 1212 traction controller
), which allows it to be used for regenerative braking.
4.6.2
Gearbox
A drive gearbox is used to transfer energy from the motor to the drive wheel. The gearbox is
sealed and maintenance-free, but should be lubricated annually or every 1000 hours with a
mineral-based grease with Lithium and Molybdenum Disulphide (MoS
2
) additives.
4.6.2.1
Greasing the gearbox
Observe the following procedure to
grease the drive gearbox.
1.
Prepare the Quikstak for
service and remove the outer
cover all as per
2.
Unscrew and remove the
secondary cover above the
drive wheel assembly.
3.
Use a grease gun to inject
~110 grams of mineral-based
MoS2 grease
into the grease
nipple, as shown by Figure 15.
4.
Replace the secondary cover
and outer cover.
Motor, gearbox & wheel assembly 1030381535
Figure 15
Summary of Contents for QUIKSTAK QS10MM
Page 1: ...User Manual Quikstak QS10MM Original Instructions English v52 0 April 2022 USER MANUAL...
Page 3: ...User Manual Quikstak QS10MM Original Instructions English v52 0 April 2022 Page 2...
Page 26: ...4 4 9 Wiring diagram C O N TR O L L ER C U R TIS1212...
Page 36: ...Date Name Location Checks complete Maintenance carried out Parts used...
