9
SimpliFire • SF-WM36 • 2040-902 Rev. F • 1/14
Figure 4.6 Installing Anchors in Hollow Wall
Figure 4.4 3/16 Toggle-Bolt Anchor
•
Four 3/16 toggle-bolt anchors are provided to ac-
comodate four of the six required anchor points. Use
of toggle bolt anchors requires drywall thickness of
minimum 1/2 in.
•
Insert the bolt through the front side of the mounting
bracket and thread the toggle onto it from the rear of
the bracket. See Figure 4.5.
•
Fold the toggle wings fl ush against the bolt and push
them through a drilled hole until they expand open
on the other side. See Figure 4.6.
•
Pull back on the bolt and tighten. See Figure 4.4.
Note:
This product cannot be installed on a wall
sheathed with drywall less than 1/2 in. thick, unless
all six anchor points in the mounting bracket align
with structural framing members.
WARNING! Risk of Damage or Personal Injury! Al-
lowable pull-out and shear strength are 25% of ultimate
values or less, as required by building authorities.
Framed Wall
•
For each of the marked anchor point locations, de-
termine which points align with a structural framing
member.
•
At the points where a wood or metal framing mem-
ber exists, the 5 x 40 screw can be installed directly
into that structural member. See Figure 4.3.
•
Every mounting hole that does not align with a
structural framing member, a wall board toggle-bolt
anchor must be used. See Figure 4.4.
Figure 4.5 Toggle Bolt Installation through Mounting Bracket
C. Appliance Installation
• Hang appliance on the mounting bracket.
• Align the slots on the back of the appliance with the
hooks on the top two corners of the bracket.
• Hang the appliance and pull down to ensure the hooks
are fully engaged. See Figure 4.7.
• Secure the appliance to the bracket with two M5x10
screws. See Figure 4.7.
1
2
Secure with screw on each
side of appliance.
Figure 4.7 Attaching Fireplace to Bracket
Mounting Hooks
Point Up
