12
13
Maintenance
Operating Instructions
Using the Front Utility valve
(CI4, CI6 and CI10 models)
To use the vacuum inlet integrated into your central vacuum, simply connect
the hose and flip the integrated switch to the “on” position. Please note that the
integrated switch will start the power unit, even if there is no hose connected to
the inlet.
Caution: Your central vacuum must not be operated without a hose or
when all inlets are closed. This could cause irreversible damage
to the power unit.
Maintenance Suggestions
Your unit is equipped with an electronic
timing board that will suggest, by the color
of the blinking LED, the type of maintenance
that should be done. These signals are only
suggestions and do not indicate a problem
with your unit. Your central vacuum will work
normally despite the flashing LEDs. When you
initially connect your unit, the LEDs will be
green and steady.
HEPA Bagged
Models B2, BF4, BF6, and BF10
Blinking Green
• Change the bag
• Empty the dust receptacle and clean the permanent filter
Blinking Amber
Plan to have your unit checked by an authorized service
center soon.
• Change the carbon dust filter
• Change the bag and check the permanent filter
• Empty the dust receptacle and clean the permanent filter
Blinking Red
It is time to have your unit checked by an authorized
service center.
• Change the bag and check the permanent filter
• Empty the dust receptacle and clean the permanent filter
Blinking Green / Amber / Red
The unit requires service.
To reset the electronic timing board
Hold the reset switch for 10 seconds.
Filtered Cyclonic
Models C2, CI4, CI6 and CI10
