8
Section 2 – OPERATING INSTRUCTIONS
2.1 PRE-START CHECK LIST
Read, understand and follow instructions and
warnings in this manual and on the machine, engine
and attachments before operating. Know the controls
and the proper use of the machine before starting.
Make the following checks and perform the service
required before each start-up.
2.1.1.
Check guards, deflectors and covers to make
sure all are in place and securely tightened.
2.1.2.
Carefully inspect machine for loose, missing,
damaged or worn components. Repair or replace as
necessary before operating the machine.
2.1.3
. Carefully inspect the debris bag and bag
adapter for wear and deterioration. IMPORTANT –
open top of bag to inspect interior of bag and the
discharge deflector end of the bag adapter. Replace
bag and bag adapter if they display signs of
deterioration. The debris bag must be attached to the
bag adapter, the bag adapter mounted onto the
machine, and the zippered top fully closed before
starting engine. The top rear corners of the bag are
attached to the handles by using the cloth straps
located near the top of the bag. See Figures 2.2 and
2.3.
2.1.4.
Check engine oil and add oil as needed to
bring level up to the FULL mark. Refer to engine
owner’s manual for oil specifications. See Figure 2.1.
FIGURE 2.1
2.1.5.
Check engine speed control to insure it
works freely.
2.1.6.
Clean exterior surfaces of machine and
engine of any accumulation of dirt, grass, oil, etc.
Keep engine air intake screen and cooling fins clear
at all times.
2.1.7.
Add fuel to tank after pushing the machine
outside where fumes can dissipate. Make sure fuel
filler cap is tight after refueling. Refer to engine
owner’s manual for fuel specifications.
2.1.8.
Adjust height of vacuum inlet. Lift up on
handles. Squeeze height control lever against handle.
Raise or lower handles until desired inlet height has
been obtained. Release control lever. See Figure 2.4.
FIGURE 2.2
FIGURE 2.3
FIGURE 2.4
SAFE LEVEL
AREA
BAG ADAPTER
MOUNTED.
BAG
ATTACHED TO
HANDLES. TOP
ZIPPER FULLY
DEBRIS BAG
AND BAG
ADAPTER
MOUNTED TO
DISCHARGE
OPENING
HEIGHT
CONTROL
LEVER
No
t fo
r
Rep
rod
uct
ion
