Installation Instructions
54” Turbo Blower
Form No. 1720927-06
Rev. 03/2007
© 2007 Briggs and Stratton, Inc. All Rights Reserved
TP 200-2325-06-AT-SMA
M A N U F A C T U R I N G , I N C .
500 N Spring Street / PO Box 997
Port Washington, WI 53074-0997 USA
NORMAL INSTALLATION AND
REMOVAL
Installation
1. Insert the tapered spacers (B, Figure 11) through the
bottom of the blower housing (A).
2. Install one spring clip (C) on each of tapered spacers
(B).
3. Hook the bottom of the turbo on the bottom hook
bracket.
4. Use the release lever to release tension on the belt,
and install the belt on the arbor pulley (see Figure
12).
5. Rotate the belt cover into position and secure with
the plastic knob (D, Figure 11).
6. Install the spring (F). Connect the top of the spring to
the bracket (E) and the bottom to the hole in the
mower deck shell, just behind the discharge opening.
Removal
1. Remove the spring (F, Figure 11).
2. Loosen the plastic knob (D, Figure 11).
3. Use the release lever to release tension on the belt,
and remove the belt from the arbor pulley (Figure 12).
4. Remove the spring clips (C, Figure 11) from the
tapered spacers (B).
5. Remove the turbo assembly (A) from the deck.
6. Close the small belt cover and secure with the plastic
knob (D, Figure 11).
7. Return the deflector to the down position.
NOTE: The baffles (Figure 10) do not need to be
removed.
FRONT
Figure 12. Install Turbo
WARNING
The deflector must be properly installed in the
down position and retained by the spring. Do not
operate the unit without a deflector.
Figure 11. Install Turbo
A. Turbo Blower Assy.
B. Tapered Spacers
C. Spring Clips
D. Plastic Knob
E. Bracket
F. Spring
A
E
F
B
C
C
B
D
