11
Operation
FREE-WHEELING AND
TRACTION DRIVE LOCK
For easy turning when pushing the snowthrower, you
can disengage the traction drive at one or both wheels
by using the Traction Lock Pins (See Figures 11 & 12.)
1. Turn the unit off, remove the Engine Key, and discon-
nect the spark plug wire.
2. To DISENGAGE the traction drive lock, insert the
Traction Lock Pin through the outer hole in the axle.
(See Figure 8).
3. To ENGAGE the traction drive lock, insert the pin
through the hub and axle (See Figure 9). If the hole in
the hub is not aligned with the inner hole in the axle,
push the snowthrower until the holes align and install
the Traction Lock Pin.
NOTE: When snowthrowing with the full width of the
auger, for best drive performance engage both wheels.
For easier turning when not using the full width of the
auger, engage one wheel and use the engaged side as
the snow contact side for the auger.
Figure 11. Traction Drive Lock - Disengaged
Figure 12. Traction Drive Lock - Engaged
WARNING
Never store snowthrower, with gasoline in engine or
fuel tank, in a heated shelter or in enclosed, poorly
ventilated enclosures. Gasoline fumes may reach an
open flame, spark or pilot light (such as a furnace,
water heater, clothes dryer, etc.) and cause an explo-
sion.
Handle gasoline carefully. It is highly flammable and
careless use can result in serious fire damage to
people and property.
Drain fuel into an approved container outdoors away
from open flame or sparks.
AFTER EACH USE
Normal use of the snowthrower may result in a build-up
of packed snow in and around the starter cord housing
and around engine controls. Heat from the engine will
usually prevent the snow from freezing solid while the
unit is running, but after the engine is shut down, some
snow may continue melting from engine heat, and later
freeze around some moving parts as the unit cools.
After each period of use, follow these steps
to prevent
freeze-up caused by ice formation in and around the
engine controls and external parts.
1. Before shutting off the engine, pull the starter rope
out 2 - 3 times, and allow it to rewind slowly. This will
help clear packed snow from the starter cord area.
2. Stop the engine by moving the Throttle Lever (See
Figure 8) down, or by pulling out the Engine Key.
3. Disconnect the spark plug wire, and position it away
from the spark plug.
4. Brush snow and ice from the snowthrower. Be sure to
clear engine and snowthrower controls, discharge
chute, worm and chute rod gears, clutch rod areas,
and anywhere else snow has accumulated.
5. Always remove the Engine Key and store in a safe
place to prevent unauthorized use.
6. If the snowthrower is kept in a cold shelter, fill the fuel
tank to prevent condensation. Do not store near
sparks or flame.
Note: The Engine Owner’s Manual contains further infor-
mation on preventing ice formation and freeze-up.
Klik-Pin In
OUTER Hole
Klik-Pin In
INNER Hole
