12
Attaching & Removing
Figure 18. Attach Dozer
A.
Dozer Pins
B.
Clevis Pin
C.
Attachment Hooks
A
B
C
Figure 19. Install Angling Arm
A.
Hair Pin Clip
B.
Support Arm Eye Bolt
C.
Angling Rod
A
A
C
A
B
Figure 21. Angling Cable Adjustment
A.
Hair Pin Clips
B.
Locking Tab
C.
Clevis Pin & Hair Pin
D.
Angling Cable
A
A
C
D
B
Figure 20. Front Hitch Mounting Brackets
A.
Upper Rod
B.
Lower Rod
C.
Hairpin Clip
D. Angling Cable
A
D
B
C
Attaching Dozer Blade
1. Install the lift arm extension if not already done (see
Install Lift Extension under INITIAL SETUP).
2. Fully lower the attachment lift.
3. See Figure 18. Attach the dozer to the tractor by
resting the dozer pins (A) on the front attachment
hooks (C).
4. See Figure 18. Install two clevis pins (B) on both
sides and secure with safety clips.
5. See Figure 17. Attach the dozer lift arm (B) to the
hitch lift arm (E) using a clevis pin and safety clip.
NOTE: At this point during initial installation tighten the
capscrews (C, Figure 14) securing the rear hitch mount-
ing brackets. This is only necessary when installing the
attachment for the first time.
6. See Figure 19. Separate the angling rod (C) and
insert it through the support arm eye bolt (B).
7. See Figure 20. Assemble the upper angling rod (A)
and lower angling rod (B). Insert a hairpin clip (C)
through the rod to secure. Be sure to route the cable
(D) through the hairpin as shown in Figure 20.
8. See Figure 19. Attach the angling rod to the back of
the dozer blade using a hair pin clip (A).
9. See Figure 21. Attach the cable (D) to the dozer
using hair pin clips (E) as shown.
10. See Figure 21. Attach the end of the angling cable to
the locking tab (B) using a clevis pin and hair pin clip
(C).
11. Lubricate the dozer as shown in the Maintenance
section.
12. Perform all adjustments as shown in the Adjustments
section.
