Installing Spout Control
1. See Figure 6. Loosely assemble spout control
rod support to left side of hitch using bracket and
hardware supplied with snowthrower.
2. See Figure 6. Install spout control rod (F) through
support and attach to spout using eye hook (G)
and clip (H).
bracket mounting hardware, making sure
spout control rod (F) is free to turn.
If necessary, reposition rod support (A).
HITCH ASSEMBLY
1. See Figure 7. Tilt snowthrower assembly onto
front side and remove the plastic cover (A).
2. See Figure 7. Remove the capscrews (B), nuts
(C) and bearing support cover (D) in order to
expose the belt pulley. Remove two carriage
bolts from inside of bearing flange.
NOTE: Do not remove any other hardware at this
time or misalignment of
and other
parts
occur.
3. See Figure 8. Install hitch assy. (A) to
snowthrower using the pins (B) and safety clips
(C) supplied. Position hitch assy. forward until it
rests on chute.
NOTE: See Figure 8. For Landlord/l 700
models, attach the the hitch to to the upper
holes on the
Use the lower
holes
models.
4. Carefully roll the belt onto the pulley.
5. Install the bearing support plate,carriage bolts,
capscrews and nuts as shown in Figure 6. Install
plastic cover.
6. Install the belt on all pulleys (see Figure 9).
Figure 9. Belt Routing
A. V Pulley
D. Back-Side Idler Pulley
B. Back-Side Idler Pulley
E. Back-Side Idler Pulley
C. V Idler Pulley
F. PTO Pulley
I
Figure 6. Spout Control
A. Rod Support
E. Nut,
(Qty. 3)
B. Bracket
F. Rod
C. Capscrew, Hex,
G. Eye Hook
116 x1-114
3)
H. Hairpin Clip
D. Lo&washer (Qty. 3)
40” SNOWTHROWER
Figure 7. Bearing and Belt Pulley Cover
A. Plastic Cover
C. Nut, Flange,
Capscrew,
D. Bearing Support Plate
6.
Hitch Assv.
A.-Hitch Assy.
B. Pin
C. Hairpin Clip
Landlord I
2700
I
2600
7
