2
This publication discusses the following topics:
Topic
See Page
TrueAlert Is Wiring
2
TrueAlert Is Class B Wiring
3
TrueAlert Is Class A Wiring
4
Mounting the TrueAlert Is Module
5
Setting the TrueAlert Is Module Address
6
Figure 1. TrueAlert Is Module
Warning:
Make sure that all power is disconnected before starting the installation.
Caution:
Connect Wiring to terminals as shown. Do not loop wires under terminals.
Break wire runs to provide supervision of connections. Do not bring conduit
through the rear of the electrical box. Strip lead insulation to 3/8” maximum.
1.
At the electrical box, connect the contractor wire to the PORT 1/PORT 2 (+ and -) terminal of
the TrueAlert Is Module. See figure 2 and 3, TrueAlert Is Class B and A
Wiring.
2.
Ensure that correct polarity is maintained across the ports.
3.
Ensure that the CKT +’s or -’s are not crossed between ports.
4.
Do not loop wires under the terminals.
Installation instructions, Continued
Installation instructions, Continued
In this Publication
TrueAlert Is
Wiring