Note: Sometimes two different gear pockets are away from alignment by
exactly the same distance – this indicates that the current code uses two differ-
ent number buttons (example, 2 and 4) depressed at the same time as part of
the code combination.
Using a small flat blade screw driver or your thumbnail, depress the key
stem which corresponds to the gear pocket which has been rotated the
farthest away (out of alignment) from the “L” shaped leg. When
depressed, the key stem(s) should stay down and the corresponding
gear pocket(s) should move closer to its corresponding “L” leg, closer to
alignment. Record the key stem number. This is the first number of your
combination.
Note: If two gear pockets are at the same distance, depress both of these
corresponding key stems at the same time.
Continue by pressing the key stem that corresponds to the gear pocket
that was the next furthest away (do not include gear pockets that have
already been rotated). Record each key stem number that is depressed.
Continue this procedure until all five gear pockets are aligned with their
corresponding “L” shaped legs on the unlocking slide. The combination
is the recorded numbers, in the order recorded.
Note: If you depress the wrong key stem by mistake, rotate the reset cam back
toward you, (toward the key stems and release). This resets the code gears and
you must repeat the above procedure, Step 3.
4.
Clearing the Current Code and Setting a New Code
Note: Align the code gear pockets with the “L” shaped legs.
Depress the code change button (i) located on top of the combination
chamber once and release
(see figure 6)
.
Rotate the reset cam back toward you with your finger (toward the key
stems) as far as it will go and release.
Enter your new combination code by depressing the key stem
corresponding to the first number (1 through 5) of your code. For
example, if the new code is 3-2-5, then you would depress 3 first, then 2
and finally 5. Record this new combination code for future reference.
Push the shoulder (j) at the bottom of the Unlocking slide up toward the
code change button and release. If each of the 5 “L” shaped legs of the
unlocking slide engages snugly inside its corresponding code gear
pocket, then it confirms that the new code has been successfully
changed. Rotate the reset cam (g) back toward you and release.
Note: If all 5 “L” shaped legs do not align fully with their corresponding
code gear pockets, repeat the procedures 3 and 4.
