Assembly instructions for kit #14
8
This is not a Lego® product even if it contains Lego® bricks and plates. All warranties provided by Simple Motors.
LEGO® is a trademark of the LEGO Group of companies which does not sponsor, authorize or endorse this product.
All rights reserved. 2014 Simple Motors, LLC
♦
www.simplemotor.com
♦
16. Wind bare wire ends tightly around the reed switch / ZNR contacts.
17. Screw twist-on connectors. Do not over tighten as you may break the reed switch!
18. You may tape the electromagnet wire that is connected to the reed switch to the side of the
rotor stand (clear tape is shown). Make sure the tape is below the axle hole.
If you plan to add a generator from the generator kit to your motor you also need to add
1x2 plate under the motor shaft.
