6.3.3.1 Disassembly
If you need to disassemble the half cylinder, please proceed as follows:
1. Using a tool such as a screwdriver, grip into the two slots in the plastic
disc between the thumb-turn and the profile cylinder housing and turn
the tool while applying a little pressure. This breaks the disc.
2. Remove the remains of the plastic disc.
3. Engage the half cylinder using an authorised ID medium.
4. While the thumb-turn is engaged, turn it anti-clockwise until it will turn
no more (e.g. towards the lock when installed or holding the cam with
your hand when not installed; see Step A in the diagram).
5. Press thumb-turn towards profile cylinder housing until it stops (you will
hear it click. If necessary, move thumb-turn backwards and forwards
several times until you hear a click; see Step B and D in the diagram).
6. If needed, engage the half cylinder once more using an authorised ID
medium.
7. While the thumb-turn is engaged, turn it anti-clockwise and apply pres-
sure against the stop position (see Step B and D in the diagram).
8. While applying pressure, pull the thumb-turn (including inside tube)
from the profile cylinder (see Step D in the diagram).
NOTE
You must not strike the thumb-turn during installation. Do not allow the
cylinder to come into contact with oil, paint or acids.
SmartIntego
Locking cylinder
(Manual)
6. Installation guide for 'SmartIntego'
23 / 44