11
12
ASSEMBLY AND OPERATING INSTRUCTIONS
Working with detergent ensures a quick soaking of the dirt, and allows the high-pressure
water to penetrate and remove the dirt more effectively. Always spray detergent on a dry
surface, do not pre-soak area. Wetting the surface first dilutes the detergent and reduces
its cleaning ability.
To apply detergents you must be operating at low pressure. This provides a gentle
application of detergent, with the pressure equivalent to the lowest garden hose. The
high-pressure setting is used for cleaning; you cannot apply detergents when working at
high pressure. Always test detergent in an inconspicuous area before use.
CAUTION
Only use cleaning detergents recommended for pressure washers.
WORKING WITH DETERGENTS
1
Engage gun safety lock.
Attach the low-pressure spray tip (black) for
soap application.
3
2
Turn on the pressure washer. Pull trigger to operate unit. The liquid detergent will automati-
cally mix with water, and be discharged through the nozzle. Apply detergent to a DRY work
surface, from bottom to top.
Gently pull detergent containers out of storage position, and fill with detergent. Push
containers back into storage position.
SHUTTING DOWN AND CLEANING UP
1
3
2
4
(If you are not using detergent, go directly to Step 2.) When you have finished using
the detergent injection system, fill detergent bottle with clean water. Siphon water at
low pressure for one minute so that all detergent is flushed through system. Remove
detergent bottle and rinse it until it is thoroughly cleaned.
Unplug the power cord from the outlet.
Turn the switch to “OFF” (0) position.
Press trigger to release any remaining water pressure.
5
6
Disconnect the garden hose from the water inlet on the unit.
WARNING
Turn off water supply and squeeze trigger to depressurize the unit. Failure to do so
could result in personal injury due to discharge of high-pressure water.
TAKING A BREAK
1
3
2
Engage gun safety lock.
Engage gun safety lock.
Unplug the power cord from the outlet.
Turn unit to “OFF” (O) position.
If taking a break of five minutes or more:
ASSEMBLY AND OPERATING INSTRUCTIONS
4
5
6
Allow detergent to remain on the surface for a short time before rinsing. Do not allow
detergent to dry on surface.
Rinse with clean water under high pressure. On a vertical surface, rinse from the
bottom up, then rinse from the top down to avoid streaking. Hold nozzle 6-8” (15-20
cm) from the work surface, at a 45° angle.
When you have finished using the detergent injection system, fill detergent bottle
with clean water. Siphon water at low pressure for one minute, so that all detergent
is flushed through system. Remove detergent bottle, and rinse it until it is thoroughly
cleaned.
CAUTION
Damage may occur to painted surface if chemical is allowed to dry on surface. Wash
and rinse a small section at a time. Avoid working on hot surfaces or in direct sunlight.