5.5. Antenna Replacement
Only use the antennas supplied. Use of other antenna types will void type approval.
This radio transmitter (IC:11443A-X10DRMD) was approved by Industry Canada to
operate with the antenna types listed below the maximum permissible gain and
required antenna impedance for each antenna type indicated.
Types of antennas is not included in this list, having a higher gain than the maximum
gain indicated this type are strictly prohibited for use with this device.
5.6. Charging your MWRSM
To charge MWRSM, use only the Simoco mobile or desktop charger.
When you use the Simoco desktop charger to charge MWRSM, make sure that the
power adapter is fully assembled before you plug it into a power outlet. Then insert
the SIM AC/ DC plug pack firmly into the power outlet. Do not connect or disconnect
the SIM AC/DC plug pack with wet hands.
The Simoco AC/DC plug pack may become warm during normal use. Always allow
adequate ventilation around the SIM AC/DC plug pack and use care when handling.
Unplug the SIM AC/DC plug pack if any of the following conditions exist:-
1. The power cord or plug has become frayed or damaged.
2. The adapter is exposed to rain, liquid, or excessive moisture.
3. The adapter case has become damaged.
4. You suspect the adapter needs service or repair.
5. You want to clean the adapter.
5.7. Cleaning your MWRSM
Clean MWRSM immediately if it comes into contact with any contaminants that may
cause possible malfunctions for example, ink, dyes, makeup, dirt, food, oils, and
lotions.
To clean MWRSM, unplug all cables and turn off MWRSM (press and hold the manual
On/Off button). Then use a soft, slightly damp cloth. Don’t use abrasive household or
industrial cleaners, aerosol sprays, solvents, alcohol, ammonia to clean MWRSM.
5.8. Connectors and Press Buttons
Never force a connector into a port or apply excessive pressure to a button, because
this may cause damage that is not covered under the warranty.
Doc Number:
TNM-U-E-0180 ISSUE 1.1
Page
15
