SLFL Instructions – LED Sports Light
Simkar Lighting
700 Ramona Ave, Philadelphia, PA 215-831-7700
www.simkar.com
70-62938
2
Re-assemble Glare Shield
Important
Please read all instructions before installing light fixture. If
you have any questions. Contact your local
representative. Retain this instruction sheet for future
reference.
Disconnect power before performing installation or
maintenance. Failure to do so may cause injury or death
due to electrical shock.
To be installed ONLY by a qualified electrician.
Do not make or alter any open holes in the luminaire. Do
not modify the luminaire!
Fixture is not intended to be connected to a two wire
ungrounded supply.
Fixture must be grounded!
Always compare driver voltage with voltage available at
jobsite.
Fixture must be grounded and wired with proper polarity
to insure reliable staring and avoid the possibility of
electric shock. Should your building service not have a
black, white and ground wire, consult a qualified
electrician.
Handle fixture with care to avoid possible cuts or
abrasions from exposed metal edges. We suggest gloves
be worn when installing this fixture.
All fixtures must be installed in accordance with local and
National Electric Code. Manufacture assumes no
responsibility for improper or application of this lighting
fixture.
Re-assemble Mounting Bracket
Note
Upon receipt of the fixture, thoroughly inspect for any freight
damages. This should be brought to the attention of the
delivery carrier. Examine contents of carton(s) and fixture.
Be sure you have received the correct merchandise.
Before Installation
1. Remove the glare shield, re-assemble the shield to
face forward. Shield is shipped in reverse to protect
from damage. Failure to reverse the shield will void
your warranty. Remove caution label on top of the
glare shield when this complete.
2. Assemble the support bracket to the main housing
fixture. The support bracket is shipped detached for
packaging.
Installation
Make certain that the supplied voltage matches the pre-
wired voltage, which is being installed.
U1 = 120 Volt
– 270 Volt
U3 = 347 Volt
– 480 Volt
