User manual - INDICATOR TRS-10a
4.
DEVICE INSTALLATION
The unit has been designed and manufactured in a way assuring a high level of user
safety and resistance to interference occurring in a typical industrial environment. In order to
take full advantage of these characteristics installation of the unit must be conducted correctly
and according to the local regulations.
- Installation should be conducted by qualified personnel .
- Read the basic safety requirements on page 3 prior to starting the installation.
- All installation works must be conducted with a disconnected power supply.
4.1.
UNPACKING
After removing the unit from the protective packaging, check for transportation damage.
Any transportation damage must be immediately reported to the carrier. Also, write down the
unit serial number on the housing and report the damage to the manufacturer.
Attached with the unit please find:
- warranty,
- user’s manual for
unit (device)
4.2.
ASSEMBLY
- Disconnect the power supply prior to starting assembly.
- Check the correctness of the performed connections prior to switching the unit on.
To install the device prepare pinholes accordingly to Figure 4.1. Back side of the
case (with mounting holes) should be mounted to a wall using screws.
Figure 4.1. Distances between pinholes
5
34 mm
4
6
m
m
