Simex SRT-94-XA, User Manual

Page: 32 / 44

User manual - METER SRT-94-XA
Register Write Range Register description
01h No
see
m
easurement
range
Measurement value (no decimal point)
02h No 0h, A0h, 60h
The status of the current measurement; 0h - data valid; A0h -
top border of the measurement range is exceeded; 60h -
bottom border of the measurement range is exceeded;
03h No 0 or 2
Decimal point position, constant value:
0 ( without decimal point) - for thermocouple ranges
2 ( two digits after decimal point) - for diagnostic range
04h Yes see descr.
State of the relays and alarm LED (binary format)
(1 - on, 0 - off):
00000000 000edcba
a - relay R1; b - relay R2; c - relay R3; d - relay R2; e - alarm
LED;
If written, only
a , b , c , d bits are important (others are ignored)
these bits allows user to control the relays via RS-485
interface
05h 1 Yes 0h ÷ 1800h
State of current output, expressed in 1/256 mA units – it
means that high byte express integer part, and low byte
fractional part of desired output current.
06h No
see measurement
range
Peak (drop) value (no decimal point)
08h No 0 ÷ 50 Temperature inside device housing expressed by 1°C
10h Yes 0 ÷ 8
“ tyPE ” parameter in “ InPt ” menu (input type).
0 - thermocouple input K; 1 - thermocouple input S;
2 - thermocouple input J; 3 - thermocouple input T;
4 - thermocouple input N; 5 - thermocouple input R;
6 - thermocouple input B; 7 - thermocouple input E;
8 - diagnostic voltage range
12h Yes 0 ÷ 5
“
FiLt
” parameter in “
InPt
” menu (measurement filtering rate)
18h Yes -99 ÷ 99
“ toFS ” parameter in “ InPt ” menu (shift of measurement
scale), expressed by 1°C
20h 2 Yes 0 ÷ 199 Device address
21h No 20B8h Device identification code (ID)
22h 3 Yes 0 ÷ 7
“bAud” parameter in “rS” menu (baud rate);
0 - 1200 baud; 1 - 2400 baud; 2 - 4800 baud; 3 - 9600 baud;
4
- 19200 baud;
5
- 38400 baud;
6
- 57600 baud;
7
- 115200
baud
23h 4 Yes 0 ÷ 1
“mbAc” parameter in “rS” menu (permission to write
registers via RS-485 interface); 0 - write denied ; 1 - write
allowed
24h Yes see descr.
Parameters of “ SECU ” menu (binary format (0 - „ oFF ”, 1 -
„ on ”):
bit 0 - “ A r1 ” parameter; bit 1 - “ A r2 ” parameter
bit 2 - “ A r3 ” parameter; bit 3 - “ A r4 ” parameter
32