Simex SRT-77, User Manual

Page: 30 / 40

User manual - METER SRT-77-XA
8. THE ALARM LED
Alarm LED (
AL
) lights in cases:
• exceeding of permissible measurement range
• detection of sensor malfunction (break of measurement circuit)
9. THE MODBUS PRO TOCOL HANDLING
Transmission parameters: 1 start bit, 8 data bits, 1 or 2 stop bit (2 bits are send, 1 and 2 bits
are accepted when receive), no parity control
Baud rate: selectable from: 1200 to 115200 bits/second
Transmission protocol: MODBUS RTU compatible
The device parameters and display value are available via RS-485 interface, as HOLDING-
type registers (numeric values are given in U2 code) of Modbus RTU protocol. The registers
(or groups of the registers) can be read by 03h function, and wrote by 06h (single registers) or
10h (group of the registers) accordingly to Modbus RTU specification. Maximum group size for
03h and 10h functions can not exceeds 16 registers (for single frame).
The device interprets the broadcast messages, but then do not sends the answers.
9.1. LIST OF REGISTERS
Register Write Range Register description
01h No -999 ÷ 6000 Measurement value (no decimal point)
02h No 0h, A0h, 60h
The status of the current measurement; 0h - data valid; A0h - top
border of the measurement range is exceeded; 60h - bottom border
of the measurement range is exceeded;
03h No 1
Decimal point position, constant value: 1 - “ 0.0 ”;
04h Yes see descr.
State of the relays and alarm LED (binary format)
(1 - on, 0 - off):
00000000 000e00ba
a
- relay R1;
b
- relay R2;
e
- alarm LED;
If written, only a , b bits are important (others are ignored) these
bits allows user to control the relays via RS-485 interface
06h No -999 ÷ 6000 Peak (drop) value (no decimal point)
10h Yes 0 ÷ 2
“ tyPE ” parameter in “ InPt ” menu (input type).
0 - Pt-100; 1 - Pt-500; 2 - Pt-1000
12h Yes 0 ÷ 5
“ FiLt ” parameter in “ InPt ” menu (measurement filtering rate)
18h Yes -99 ÷ 99
“ toFS ” parameter in “ InPt ” menu (shift of measurement scale),
expressed by 1°C
30
i