Simex SRD-99, User Manual, Page: 81 / 112

User manual - DATA RECORDER SRD-99 and cooperating software
Fig. 2.1. Selection of serial port and baud rate
After defining the communications port and baud rate, go to device detection screen (
Fig. 2.2
)
by clicking on the [
Next>>
] button.
Prior to scanning the network for devices, set the addresses identifying the selected devices in
the network (a different address for each device – see page
56 ). In order to detect units
connected to the network (after assigning addresses to the devices) press the [ Scan network ]
button.
Address set in the unit should be in 1
÷
254 range. Devices with not changed
address will not be found by software !
81
i