User manual - DATA RECORDER SRD-99 and cooperating software
Fig. 2.2. Scanning network for devices
The list shown on the figure (Fig. 2.2) contains one detected device. Order of devices on the
list corresponds to the order of addresses assigned by the user to individual devices. Once all
devices are detected press [
Break scanning
] button.
„Properties”
list available in right part of the window allows configuration of measurement
channels. Appropriate names (e.g. the location where the sensor connected to this channel
was installed), unit denotation and allowable measured values (minimum and maximum)
should be assigned to measurement channels of detected devices. In case these values are
exceeded during system operation an alarm message will be displayed.
After pressing the [
Next>>
] button the final installation screen will be displayed.
82
