User manual for RTD,TC,mV/4-20mA converter module SPT-86L
9.
DEFAULT AND USER'S SETTINGS LIST
Parameter
Description
Default value
User's value
Measurement input configuration (”Input” group of registers)
InputType
Input type
Pt 100
InputConn
RTD's connection method
4-wire
InputFilter
Filtering ratio
0
TempOffset
Shifting of measurement scale
0.0
InputChar
Conversion characteristic mode
linear
InputPoint
Decimal point position
0.0
InputLow
Minimum returned value (for nominal range)
000.0
InputHigh
Maximum returned value (for nominal range)
100.0
InputHiRange
Extension of the top of the nominal input range
5.0 (%)
Active current output configuration (”Output” group of registers)
OutMode
Current output mode
measured
value
OutLow
Measured value for which 4 mA is generated
0.0
OutHigh
Measured value for which 40 mA is generated
100.0
OutLoRange
Extension of the bottom of the nominal output range
5.0 (%)
OutHiRange
Extension of the top of the nominal output range
5.0 (%)
OutAlarm
Current output value on critical exception
22.1 mA
Peak detection function configuration (”Hold” group of registers)
HoldMode
Kind of detected changes
peak
HoldPeak
Minimum detected change
0.0
HoldTime
Maximum time of holding the peak
0.0
HoldOut
Source of current output control
current
value
RS-485 interface configuration (”Modbus” group of registers)
ModbusAddress Device address
FEh
ModbusBaud
Baud rate
9600
ModbusAccess
Permission to changes of configuration registers
yes
ModbusTimeout Maximum delay between received messages
0
ModbusDelay
Additional delay of answer transmission
0
23
