Replace the battery as follows:
1. Remove the 4 screws at the back of the trainer device (Torx 6).
2. Remove the upper red part of the housing.
3. Remove the white cover (with light guides).
4. Take out the sensor and push the battery out to the metal holder (do not dispose of the
battery with household waste but take it to a suitable waste station).
5. Insert a new 3V battery (CR2032) in the same way (+ side up).
6. Place back the sensor (this is only possible in one way) and push the battery down for
optimal LED-light effect.
7. Place back the white cover with light guides (also this is only possible in one way).
8. Place back the upper red part (fits one way) and finally put the 4 screws back.
Turn the
SimCPR
®
Pro Trainer
on and check if the LED flashes and both light guides are well
placed so you can see both LED-lights clearly. The trainer is now ready for use again.
6
