Simco CM5, Manual

Page: 60 / 67

CM5_UM_ 9752090319_GB_V0_9 60 / 67
Appendix VI Quick Init installation configuration examples
Using a few examples, some common generator settings will be set using the Quick Init menu.

Note:
These examples can only be carried out when a generator comes from the factory or if the
factory settings have been reset.
Example 1.
Via the Quick Init menu the generator must be configured as follows:
- The generator must operate in Local mode.
- The generator must operate in Voltage Control (VC) mode.
- The External Remote HV On/Off mode is not used.
Step 1: Switch the generator on. After a short time the following text appears:
“ [Initial setup] ”
“ Use as standard ECM: ”
“ YES ”
Step 2: Depress the [ ] and/or [ ] key until the flashing text “ YES ” changes to “ NO ”.
Step 3: Depress [

]
. The following text appears:
“ [Initial setup] ”
“ Operating mode: ”
“ Local ”
Step 4: Depress [

]
. The following text appears:
“ [Initial setup] ”
“ Control mode: ”
“ VC ”
Step 5: Depress [

]
. The following text appears:
“ [Initial setup] ”
“ Remote HV on/off ”
“ source: Continuous ”
Step 6: Depress [
 ]
. The CM5 generator will now start up in the set configuration.