SVD800HD
SERVICE GUIDE
page - 4 -
1.
Safety and regulations
Introduction
•
The instruction given in this manual are meant for service engineers only. A good knowledge of electronics and
mechanical engineering is absolutely necessary to repair and maintain the SVD800HD projector.
Important notes
•
Should any question after reading this manual arise, please contact your local SIM2 distributor, who will be glad to
help you.
•
In the interest of our customers we keep on improving the product. Therefore SIM2 reserves the right to change all
technical specifications and further information provided in this manual at any time without prior notice.
About this manual
•
This manual is intended for those who are doing repairing work and maintenance on the SVD800HD.
•
This manual has the following goals: to enable technicians to perform the necessary maintenance and repair work to
keep the unit in good operating condition.
•
In case of relevant changes, the information provided in this manual could be updated with the issue of technical
notes.
Safety information
•
This projector has been made in compliance with
EN 60950
standard relative to the safety of information technology
equipment.
•
This projector has been made in compliance with
EN 50082-1
(Generic immunity law),
EN61000-3-2
(Limits for
Harmonic current emission),
EN55022
(Limits and measuring methods of radio disturbance produced by information
technology equipment),
EN6100-3-3
(Limits- section 3 Limitation of Voltage Fluctuation and Flicker in low voltage
supply system for equipment with rated current SYMBOL 163\f “Symbol” 16A).
•
The accessible metal parts are connected to the power socket round terminal. When installing make sure the ground
cable is properly connected and use only the power cable and extension leads supplied with the unit. The unit must
be grounded. Interruption of the protective conductors inside or outside the unit, or disconnecting protective earthing
may cause possible danger and malfunction of the unit.
•
SVD800HD may only be maintained and serviced by qualified persons who are familiar with the machine.
•
Always disconnect the cable plug from the mains socket for those service operations that need complete cut off of the
machine.
•
To avoid damage, fire or electrical shock, do not expose the unit to rain or damp.
•
Do not lead any kind of liquid spill inside the unit.
Summary of Contents for SVD800 HD Millennium
Page 2: ...SVD800HD SERVICE GUIDE page 2 WHITE PAGE...
Page 34: ...1 2 3 5 6 9 8 7 4...
Page 35: ...1 2 3 4 5...
