SIM DATAVIEW, User Manual, Page: 7 / 30

6
corresponding unit of measurement
The lower left reading
– indicates the MIN reading
The lower right reading – indicates the MAX reading
By using the UP and DOWN arrows, you can switch between showing
the instrument reading or the battery status.
During the reading phase the following operations are possible:
HOLD - stop the reading on a desired data
OFFSET - remove a desired offset from the reading
MEM - data storage
HOLD
By pressing HOLD/OFFSET during the acquisition phase, DATAVIEW will
enter the HOLD function, which allow you to stop the reading and keep
the displayed data fixed.
The letter H will flash on the top right of the display.
By pressing ESC , you can exit the HOLD function.
OFFSET
By pressing SHIFT first and then HOLD/OFFSET during the acquisition
phase, DATAVIEW will enter the OFFSET function, which allow you to
deduct this value just measured (TARE) from the reading.
The letter O will flash on the top right of the display.
To exit and return the read value to the previous one, press SHIFT and
GAIN/OFFSET again or press ESC .