Sim Seats iRacing Pro, Owner'S Manual

Page: 2 / 7

Swing the monitor mount arms into their approximate final locations (this is important to
prevent the monitor stand from tipping backwards once the side monitors are installed).
Slide the monitor mounting plate with the monitor installed through the swing arm, install
the rear clamp, and tighten the rear clamp bolt. Repeat this for the other side.
Step 6: Final adjustments - The center monitor is fixed so no adjustment will be required
other than overall height adjustment. Side monitors, on the other hand, have a large
amount of adjustment. The arms will articulate to provide the appropriate angle and some
distance from center monitor adjustment. The side monitor plates allow for left to right, up
and down, and rotational adjustment. This will require some tweaking to get each monitor
positioned seamlessly. Once the positioning is complete, tighten all hardware.
SR-X Driving Simulator Setup:
Refer to the SR-X owner’s manual for the SR-X chassis setup. Mount the Logitech pedals,
wheel, and TH8 shifter. Slide the SR-X into position in between the monitor mount legs and
make adjustments to monitor height and angle as needed.
Keyboard Tray Setup:
Step 1: Install the mounting bracket to the left
side steering wheel upright using the u-bolt, u-
bolt plate, and nuts.
Note: This keyboard tray will
only mount on the “driver’s side”. Please contact us if
you need one for the “passenger” side.
Step 2: Align the bracket so that it is straight and
tighten the u-bolt nuts.
Step 3: Install the swing arm to the bracket.
Tighten the bottom bolt.
Step 4: Install the keyboard tray to the swing arm.
Tighten the top bolt.
Step 5: Swivel the tray as needed. Install the
Logitech wireless keyboard.
ConneX™ Speaker Mounts:
The ConneX speaker mounts are a set of universal speaker mounts that will support up to
5.1 sound systems. The left and right speaker mounts connect to the far left and right holes
in the monitor mount and the rear speaker mount clamps to the seat. Note: A wire control
kit is ideal for keeping the wires out of the way. We recommend placing the center channel
above the center monitor or below the monitor between the center monitors vertical
support posts.