Bomi Furniture P/L trading as SilverLynx ABN 99 006 489 541 11-17 Sages Road Glenroy Victoria 3046 Australia
T:+61 3 9359 4000 F:+61 3 9359 4322 E:[email protected] W:www.silverlynx.com.au
STEP 1
Slide 12 x timber slats through
the spine. After all slats have been fitted,
position the spine in the middle, as per
image below.
OR
for King Size space
the 2 spines evenly apart - 1/3 of the
width of the slats. Ensure that the slat
with a hole in either end is placed at the
centre of your bed. This is so the centre
slat can be screwed to the side rail.
STEP 2
–
You will need to prepare your
leg/s for the next stage. Roughly set up
the support leg height to fit your bed
height as shown. You may need to
remove the square tube labelled ‘bottom
section’, and flip it around so that the
thread for the screw-on foot is at the
bottom. Using the bolt and nut provided
lock the leg into position. The height can
be fine-tuned at the foot once the
system is in place (step 7).
STEP 3
–
Slide the support tube(s)
through the spine between slats as per
the recommendation on the first page
of this guide.
STEP 4
–
Be sure to slide the support
tube through the support leg at the same
time. Ensure the leg is positioned
between the spine as per diagram.
