SILVER LINE S550
16
MAINTENANCE
Main conditions of long service life is right and careful service.
Avoid excessive increasing of pressure in the board,
especially from heating by the sun rays.
After exploitation take off sand and dirt from boat surface,
and carefully dry it.
Avoid the water getting into the chambers. If a fuel or an oil
/ gas gets to the boat surface it is necessary to wash the soiling place
by soap water as soon as possible and dry.
Pay attention to the condition of bottom and seat surfaces. If
the coating is destroyed it is necessary to dry this element and restore
the defend ply.
After the season prepare the boat to winter keeping. Clean
boat surface from sand and dirt and make the necessary repairs, if
damages take place. If it is possible, keep the boat in the open and
slightly pumped state in air temperature 0-25°C. The boat must be
protected from the sun rays.
Insignificant boat repairing (eliminating the board punctures
or cuts) you may carry out by yourself. In this case use the coated
fabric patches from the complete set. Ask your dealer for the correct
type of glue you may use for the repair.
In case if sufficient damagesof hull, tube body, partitions or
seams it is recommended to apply for professional repair in authorised
service station.
OPERATING REGULATIONS
Dear user,
We thank your for your purchase and do hope that you will have a
great fun of it. However, to make your joy and pleasure complete, we
would request you to read carefully and observe the directions and
recommendations specified below.
IT IS STRICTLY FORBIDDEN :
to handle the boat in the state of intoxication and without individual
rescue means being used (life-saving belts, jackets, etc.)
IT IS FORBIDDEN :
- to overload the boat above the design weight-carrying
capacity;
- to use an outboard engine of power exceeding the
maximum
allowable value;
- to bring the tube pressure up to the value exceeding the
rated
one ( 0.15 bar/ 2.15 psi );
- to drag the boat across a rough surface.
Danger of usage of engine having insufficient or
excessive power
According to the safety regulations, each inflatable boat should be
furnished with an outboard engine having the maximum allowable
power. You will find the data on the maximum allowable power of the
engine on the manufacturer’s plate with the designation of the model
type inscribed thereon. The plate is fixed in the afterbody of the boat.
However, your should choose the engine power within the allowable
range so as to ensure that you may safely reach the shore when
heading into the wind or into the current.
