![background image](http://html1.mh-extra.com/html/silverline/h22160-006/h22160-006_service-manual_1273797011.webp)
11
the values indicating the engine outputs are not seen.
♦ Micromatch Connector Input Check
The switch cable may be faulty if the values specified in the micromatch
connector input of the switch are not observed. In such a case, a cord short
circuit test shall be performed.
♦
Short Circuit Test with Micromatch-IDC Socket;
The IDC socket output should be checked if there is no problem with the cable
of the switch.
♦ IDC Socket Output Check
Circuit is defective if there is a problem at the IDC Socket output, switch is
defective if there is no problem.
3. If the switch lights are on but the lamp is not working;
Start the lamp and measure the lamp output.
♦ Lamp Voltage Measurement
The lampholder assembly may be defective if the lamp measurements given
on the card can be made. In such a case, a cord short circuit test shall be
performed.
♦ Short Circuit Test for the Lampholder Assembly
The lamp is faulty if there is no fault in the lampholder assembly.
Measurement should be made through the micromatch input of the
switch if the values indicating the lamp outputs are not seen.
♦ Micromatch Connector Input Check
The switch cable may be faulty if the values specified in the micromatch
connector input of the switch are not observed. In such a case, a cord short
circuit test shall be performed.
♦ Short Circuit Test with Micromatch-IDC Socket;
The IDC socket output should be checked if there is no problem with the cable
of the switch.
♦ IDC Socket Output Check
Circuit is defective if there is a problem at the IDC Socket output, switch is
defective if there is no problem. 4. If the circuit is 220V at the motor socket
outlet but the motor is not running, the robustness of the windings can be
checked by checking the motor windings.
♦
Motor winding measurement