EN
Original Instructions
silverlinetools.com
13
Troubleshooting
Problem
Possible cause
Solution
Tool does not start
when ON/OFF
Switch (3) is
operated
No Battery (8) or
Battery discharged
Ensure a charged
Battery is installed
Brushes are worn
out
Return the tool to
an authorised
Silverline service
centre for repair
Defective ON/OFF
Switch or tool fault
Blade not cutting
correctly
Speed setting too
low
Increase speed
Material may not be
suitable for the
blade installed
Change blade
Material not
suitable for tool
For some materials,
including hardened
metals, compatible
blades are
unavailable. Revert
to alternative
methods of cutting
Worn blade
Replace blade
Sanding Sheet (10)
comes loose from
Sanding Pad (11)
during use
Speed set too high
Reduce speed
Too much
downward pressure
during use
Reduce hand
pressure
Hook & loop surface
of Sanding Pad worn
out
Replace Hook &
Loop Sanding Pad
Unknown
mechanical noise
or vibration
Accessory not
securely fitted
Check accessory is
fitted correctly and
securely tightened
Tool fault
Stop using the tool
and return it to an
authorised Silverline
service centre for
repair
Burning smell
Motor overheating
due to excess
pressure
Remove the tool
from the workpiece
and run with no load
for 30secs to allow
the motor to cool
down. Then
continue with the
operation, but at
reduced pressure.
Tool faulty
If the burning smell
continues after
applying the
solution above, then
switch the tool OFF
and remove the
Battery. Return it to
an authorised
Silverline service
centre for repair
Tool stops
unexpectedly.
Brushes are worn
out
Return the tool to
an authorised
Silverline service
centre for repair
Motor overheating
due to excess
pressure
Allow the motor to
cool down. Then
continue with the
operation, but at
reduced pressure.
Tool faulty
Switch the tool OFF
and remove the
battery. Return it to
an authorised
Silverline service
centre for repair
Battery Overheating
Allow the Battery to
cool down or
replace with
another charged
Battery
Summary of Contents for 948829
