Wet vacuum cleaning:
• Ensure the unit is unplugged from the power supply. Make sure the
tank is clean and free from dust and dirt.
• Remove the cartridge filter/dust bag and fit a foam filter over
the filter basket. Replace the units top section onto the container.
• Attach the same flexible hose as used in dry vacuuming and fit the
desired nozzle.
• Ensure the unit switch is off (position 0) before plugging into the
power supply.
• Press the switch to On (position I)
• After use empty the tank, clean and dry.
NOTE:
To vacuum large quantities of liquid, from a sink or tank etc.
Do not immerse the nozzle completely in the liquid. Leave a gap at
the top of the nozzle opening to allow an air inflow. The unit is fitted
with a float valve which stops the suction action when the tank has
reached its maximum capacity. The user will notice an increase in
unit motor speed. When this happens turn the unit off and disconnect
from the power supply. Remove the top of the unit and dispose of the
liquid into a suitable receptacle. To continue vacuuming refit the top
of the unit and reconnect to the power supply.
NOTE:
After wet vacuuming turn the machine off and remove the
plug from the power supply. Empty the contents and clean and dry
the unit inside and out.
WARNING:
After wet vacuuming the foam filter must be removed
and a cartridge filter/dust bag must be fitted before dry
vacuuming again.
Blowing
• Push the large end of the flexible hose into the blow connection
in the top of the motor housing.
• Ensure the switch is in the OFF position before plugging into
the power supply.
• Select the ON position 'l'.
• The unit will now blow through the vacuum hose and can be
used to clear obstructions within the pipe.
WARNING:
If after a few seconds the hose is still blocked turn off
the unit and clear the hose manually.
MAINTENANCE
• Ensure the unit is unplugged from the power supply.
• Disconnect the hose from the unit.
• Undo the clasps and remove the motor head from the container.
• Open drain outlet cover to allow the vacuumed liquid to drain out.
• Clear out any debris or dirt from the container and hose.
• Clean the foam filter with a mild soapy solution.
• Ensure that the filter is dry.
• Check the hoses and attachments, check the power cable make
sure they have received no damage.
• Ensure the switch (10) is in the OFF position before plugging into
the power supply.
• Press the switch to the ON position.
• After use empty the tank, clean and dry well.
675260_Instructions.indd 4
30/3/07 11:15:33