10 GB/IE/NI/CY
Start-up / Cleaning and Care
Furniture is now coated with a variety of paints and
plastics, and is treated with the most diverse of clean-
ers. It is therefore impossible to preclude some of
these substances may contain components which
would affect and soften the rubber feet of the housing.
If necessary, place a non-slip, heat resistant pad
under the glass kettle.
Please the base station
4
on a suitable surface.
Connect the device to the protective ground
socket.
Please boil water 2–3 times prior to first use.
To do so, fill the water reservoir to the MAX mark.
Pour out the water after each use and rinse the
water reservoir with clean water.
Always allow the water reservoir to cool to room
temperature between cycles.
Start-up
Filling the glass kettle
Remove the water reservoir
5
from the base
station
4
to fill.
Open the safety lid
8
by pressing the lid release
push button
1
.
Add water to the water reservoir
5
. Be sure
not to fill below “MIN“ or above the “MAX“
level of the level indicator
6
Only use fresh potable water.
Do not ingest water not identified as potable
water. There otherwise is a risk of damage to
the health!
RISK OF BURNS! Adding
too much water to the device poses a
risk of boiling over. This can result in
burns!
Close the safety lid
8
.
Note:
The automatic shut-off will not work if the
safety lid
8
is not closed correctly.
Placing the glass kettle on
the centre contact station
Your glass kettle features a practical centre contact
station. This means you may align the water reser-
voir
5
in any direction without observing the accu-
racy of fit.
Place the water reservoir
5
on the base
station
4
.
Now connect the base station
4
to the mains.
Boiling water
Note:
The ON / OFF switch
3
can only be used
if the device is on the base station.
Press the ON / OFF switch
3
down in the po-
sition “|“. The device is switched on. It will now
start heating. Once the water is boiling the auto
shut-off will switch the device off. The shut-off
time depends on the amount of water added.
Note:
Based on the function of the device, a
few drops of condensation may escape from
the discharge openings at the bottom of the de-
vice at the end of the boiling cycle. This is not a
sign the device is leaking but is due to the auto
shut-off and does not affect safety.
Safety ON / OFF switch
Note:
Your device features a special safety ON /
OFF switch
3
(“lift-off switch-off”). Removing the
water reservoir
5
from the base station
4
will trip
the ON / OFF switch
3
up and the device will
automatically switch off.
To use again, return the water reservoir
5
to
the base station
4
and push the ON / OFF
switch
3
down into the “|“ position.
Note:
If you do not push the ON / OFF switch
3
down again, the device will remain off, even with the
water reservoir
5
on the base station
4
.
Overheating protection
Your glass kettle features an overheating protection
which will automatically switch the device off when
Before use / Start-up
