Silvercrest SWGF 3000 B2, Operation And Safety Notes

Page: 23 / 97

22 GB/IE
˜
Operation
m
Danger of burns! The lid 3 must remain
closed when pouring hot water . Otherwise,
hot water or steam could escape over the rim
causing burns .
˜
Placing the product
Keep the power cord 6 as short as possible .
Wrap the excess power cord onto the cord
storage 8 (bottom of the base 9 ) .
Guide the power cord 6 through the power
cord guide 7 .
Place the base 9 on an even, stable surface .
Maintain a safe distance to walls and
cupboards to avoid damages caused by rising
steam .
˜
Boiling water
Fill the water kettle 12 with water through the
lid’s 3 filler flap 2 .
Place the water kettle 12 onto the base 9 .
Push the
I/O
switch 4 into the
I
position .
The LED ring 10 (on the bottom of the water
kettle 12) lights up . The colour of the LED ring
changes with the water temperature .
Colour Temperature (approx.)
Green ≤ 50 °C
Blue 51–70 °C
Purple 71–80 °C
Yellow 81–90 °C
Red > 90 °C
The product automatically turns off when the
water is boiled .
˜
Cleaning and care
m
WARNING! The product shall not be
immersed in water or other liquids . Do not
hold the product under running water .
Always disconnect the product from the power
supply before cleaning .
Check the product prior to each use for visible
signs of damage .
˜
Cleaning
Do not use any abrasive, aggressive cleaners
or hard brushes to clean the product .
Clean the product with a slightly damp cloth .
Use a mild detergent, if necessary .
Rub all parts dry with a clean cloth .
˜
Care
Cleaning the strainer
1
Fig.
Remove the lid 3 . B
Gently pull on the strainer‘s 1
clip to release it .
C
Rinse the strainer 1 with fresh
water .
–
Place the strainer 1 with its top
edge on the top of the water kettle
12 .
D
Press the strainer 1 firmly into
position .
E
Removing calcifications
Limescale reduces the efficiency of the product
and increases energy consumption . Check the
product regularly for limescale deposits .
Fill the water kettle 12 with a vinegar solution
(5 to 15 %) .