12 GB/IE/NI
Inserting / replacing batteries
Open the battery compartment cover on the
remote control.
Insert two batteries into the battery compartment
or replace the old batteries with new ones. Only
use batteries of the specified type (see „Technical
data“).
Note:
When inserting the batteries, be sure to
observe the correct polarity. This is shown in
the battery compartment.
Close the battery compartment cover on the
remote control.
Operation
Due to the complexity of domestic environments the
product may skip some areas when cleaning. For
better cleaning results we recommend using the
product daily.
Preparation
Remove any obstacles prior to use, for example
power cables, toys and other objects.
Tuck rug edges under the rug. Do not allow
curtains and tablecloths to touch the floor.
Try to position furniture properly.
Test the product in areas with stairs. This allows
you to check whether the product can detect
the edge of area which it could fall off.
Do not stand in the way of the product when it
is working. Otherwise the product will be una-
ble to clean these areas.
Cleaning
Press the Clean button on the robot vacuum
cleaner
11
or on the remote control
27
if the
display shows „88:88“. The notification will
switch to AUTO and the product will begin the
cleaning programme. If the product is in Standby
mode, the initial „88:88“ notification will ap-
pear after the Clean button is pressed for the
first time. When the Clean button is pressed for
a second time, the notification switches to
AUTO and the cleaning programme begins.
Note:
During automatic cleaning, the product
will switch to Corner mode when necessary, if
it is nearing a corner. After cleaning the corner,
the product will switch back to Normal mode.
To pause the cleaning programme part way
through, press the Clean button on the robot
vacuum cleaner
11
or on the remote control
27
.
To continue the cleaning programme, press the
Clean button on the robot vacuum cleaner
11
or
on the remote control
27
again within 15 sec-
onds. If the pause lasts longer than 15 seconds,
the product will switch to Sleep mode and the
notification in the display
1
will go off.
You can also switch the product to Sleep mode
manually. To do so, hold the Clean button on
the robot vacuum cleaner
11
down for a few
seconds until the notification in the display
1
goes off.
With the product paused, you can use the
directional buttons
26
on the remote control to
manually move it left / right / forwards / back-
wards.
Cleaning modes
For better cleaning results, the product has various
cleaning Modi. You can select the modes by pressing
the buttons on the product or on the remote control.
Spot mode
This mode is suitable for very dirty or very dusty
areas. In Spot mode, the product will focus on one
area to clean.
During cleaning, press the Spot mode button
on the robot vacuum cleaner
14
or the remote
control
29
to start this mode.
As soon as the surface is sufficiently clean, the
product continues with the automatic cleaning
programme.
Note:
You can also end Spot mode by pressing
the Clean button once on the robot vacuum
cleaner
11
or on the remote control
27
.
