76 GB
the optimum flavour. For dark roasting
the temperature should be lower and
for light roasting higher.
•
Clean your espresso machine regularly.
Coffee residues or clogged pores alter
the taste.
•
Always use fresh tap water that is not
too hard. If your tap water is hard, you
can use filtered water from a commer-
cially available water filter.
12. Extracting hot
water
DANGER! Risk of injury
through scalding!
Hot steam and hot water are released
when using the steam nozzle
10
. The
steam nozzle becomes very hot. Only
touch the steam nozzle by the plastic
handle. Never put hands or other parts
of your body in the steam.
You can draw hot water (approx. 80 °C)
from the steam nozzle
10
, for example for
an Americano or to preheat cups.
You can turn the steam nozzle
10
back and
forth.
Requirement: the device is ready to be used.
The LED rings
17
,
18
are permanently lit.
1. Place a container under the steam noz-
zle
10
.
2. Turn the dial
4
in the direction of the
symbol .
- The LED ring
17
flashes.
- The LED ring
18
goes out.
- Hot water flows from the steam noz-
zle
10
.
3. Finish the operation by turning the di-
al
4
back to
OFF
.
When the LED rings
17
,
18
are flashing,
the device is heating up.
When the LED rings
17
,
18
are permanent-
ly lit, the device is ready to prepare espresso
again.
NOTE:
the maximum time for hot water pro-
duction is 120 seconds. The function then
stops automatically. Set the dial
4
back to
OFF
. You can then immediately use the func-
tion again.
13. Frothing the milk
DANGER! Risk of injury
through scalding!
Hot steam and hot water are released
when using the steam nozzle
10
. The
steam nozzle becomes very hot. Only
touch the steam nozzle by the plastic
handle. Never put hands or other parts
of your body in the steam.
When frothing milk with the steam noz-
zle
10
: dip the steam nozzle into the
milk before you start the steam function.
And stop the steam function before you
pull the steam nozzle out again.
NOTE:
when the device is ready for steam
production, continue working quickly. Oth-
erwise the device switches to cooling mode
after a short time (the LED rings
17
,
18
flash rhythmically). This is a protective func-
tion against overheating. In this case, press
the button
19
again to reactivate the
steam function.
Summary of Contents for SSMS 1350 B2
Page 2: ...Español 2 Italiano 32 English 62 Deutsch 90 ...
Page 91: ...89 GB ...
