Silvercrest SKR 800 C3, Operating Instructions And Safety Instructions

Page: 20 / 56

GB
│
IE
│
NI
│ 17 ■ SKR 800 C3
Receiving stations in mono
♦ If you would like to receive a station in mono, press and hold the
|
ST/
MO button
q
for around 2 seconds until
4
ST
for stereo reception goes
out in the display.
NOTE
►
ST
is only displayed if the station can actually be received in stereo.
♦ If you would like to switch back to stereo reception, press and hold the
|
ST/MO button
q
again for around 2 seconds until
ST
for stereo
reception is shown in the display
4
.
Kitchen timer
The device has a practical kitchen timer with which you can monitor cooking and
baking times, for example. You can set 2 kitchen timers.
Setting and operating the kitchen timer
♦ Turn the −TIMER+ 8 dial right or left to set Timer 1. flashes in the
display 4 .
NOTE
► Timer 1 can be set in steps of 1 minute from 1 minute up to 3 hours
59 minutes. If you set the countdown to between 1 minute and 4 minutes,
the time is shown as "mm:ss". If you set the countdown to 5 minutes or
more, the time will be shown as "hh:mm".
► If no change is made to the setting for about 15 seconds, the device will
switch back to the previous operating mode without saving the settings.
♦ Press the −TIMER+ dial 8 to accept the setting. The display lights up
and the countdown for Timer 1 starts immediately.
♦ Press the button 3 to set Timer 2. flashes in the display 4 .
NOTE
► Timer 2 can be set in steps of 5 minutes from 5 minutes up to 3 hours
55 minutes. The time is given as "hh:mm".
► If no change is made to the setting for about 15 seconds, the device will
switch back to the previous operating mode without saving the settings.
♦ Press the −TIMER+ dial 8 to accept the setting. The display lights up
and the countdown for Timer 2 starts immediately.
♦ The countdown for Timer 1 and Timer 2 gives a warning beep at 30, 15,
10 and 5 seconds before expiry to indicate the alarm time.
♦ At the end of the countdown, an alarm signal with rising volume sounds.
Press the
−TIMER+ dial
8
or the − | /FUNC. dial
1
to
switch off the alarm. Timer 1 or Timer 2 goes out.