Silvercrest SKR 800 C3, Operating Instructions And Safety Instructions

Page: 17 / 56

■ 14 │
GB
│
IE
│
NI
SKR 800 C3
♦ Press the 0 button to accept the setting. The day date display flashes
on the display 4 .
♦ Turn the −TIMER+ dial
8
left or right to set the day.
♦ Press the 0 button to accept the setting. (RDS - radio data system)
flashes in the display
4
.
♦ Turn the −TIMER+ dial
8
left or right to turn the RDS function (On) or
(Off). When the RDS function is turned on the signal is strong enough,
the time and date is corrected automatically if necessary.
♦ Press the
0
button to accept the setting.
DT
(Display Dimmer) flashes on
the display 4 .
♦ Turn the
−TIMER+ dial
8 left or right to turn the display dimmer (Off)
or (On). When the display dimmer is turned on, the display illumination
is deactivated between 23:00 and 05:00. This switch-off time is pro-
grammed permanently and cannot be changed.
♦ Press the
0
button to accept the setting. The time, date and, if applicable,
DT
and appear on the display
4
. Push the −TIMER+ dial
8
to show
the year on the display
4
. The display will automatically jump back to time
after around 5 seconds.
Set alarm
Requirement:
The device is in clock/standby mode.
The device has two alarm functions. For both functions, you can programme an
alarm sound
or playback of the last selected radio station or
at a certain time.
The alarm time and alarm type are shown below left on the display
4 .
♦ Press the
|
MEM button
z
or the
|
AMS button
e
for about
2 seconds. The hour flashes on the display
4
.
♦ Turn the
−TIMER+ dial
8 left or right to set the hours.
♦ Press the
|
MEM button
z
or the
|
AMS button
e
to save the
setting. The minutes flash on the display
4
.
♦ Turn the −TIMER+ dial 8 left or right to set the minutes.
♦ Press the
|
MEM button
z
or the
|
AMS button
e
to save the
setting. (Off) flashes on the display
4
.
♦ Turn the
−TIMER+ dial
8 to the right to set the alarm type to alarm
or alarm .
♦ Turn the −TIMER+ dial 8 to the right again to set the alarm type to radio
or radio .
♦ Press the
|
MEM button
z
or the
|
AMS button
e
to accept the
selected alarm type.