Silvercrest SHBS 600 A1, Operating Instructions Manual

Page: 11 / 104

9 GB
• First, start with a comb attachment with a longer cutting length and then, in
the course of the cutting process, use shorter cutting lengths step by step. Ad-
just the cutting length with the slider
10 and read off the cutting lengths on
the marker 8 on the side of the comb attachment 1 .
• Start by cutting the hair in the neck or on the sides and cut towards the cen-
tre of the head. Then, cut the front section of the hair towards the centre of
the head.
• Hold the device in such a way that the comb attachment lies as flat as pos-
sible on the head. Move the device evenly through the hair.
• If possible, cut against direction of hair growth.
• In order to catch all the hair, move the device several times through each
section of the hair.
• Comb the hair repeatedly and well.
• In order to achieve a straight cutting line for cutting lengths over 20 mm,
the device should be passed through the hair several times from different di-
rections.
5.3 Thinning hair
Use the thinning function to reduce the volume of the hair without changing its
length.
•
Push the slider 3 to the left. The thinning function integrated into the shav-
ing head 9 is extended upwards.
5.4 Cutting hairlines and beard
WARNING! Risk of injury!
The points of the shaving head are sharp. Handle with care.
• Adjust the cutting length with the slider 10 according to the desired hair
length and read off the cutting length using the marking 8 on the side of
the comb attachment 1 . Now, shorten your beard step-by-step.
• Use the device only with the shaving head and without comb attach-
ment
9 , to cut hair very short or to cut beard and hairline. In this way you
can cut hair lengths of 1-2 mm evenly.
__GRA78917_B4.book Seite 9 Mittwoch, 5. September 2012 6:49 18