Silvercrest SFE 450 C1, Operating Instructions Manual

Page: 15 / 112

12
SFE 450 C1
GB
CY
To clean the filters 3 , use the supplied nylon brush . :
■ Turn the lid of the pusher until the arrow points to the opened lock on
the pusher shaft. You can now remove the lid. The nylon brush
.
can be
found inside the pusher . To re-close the lid, place it on the pusher so that
the arrow points to the opened lock . Then turn it until the arrow points at
the closed lock . The lid now sits firmly in place.
■ Hold the filter
3
(with the underside upwards) under running water and
clean it with the nylon brush
.
.
Colouring:
■ Some fruits or vegetables can permanently discolour parts of the juicer.
This is not damaging and does not impair the appliance in its functions.
Storage
If you do not intend to use the juicer for a long time, wrap the cable around the
cable retainer
on the underside of the juicer.
Troubleshooting
Faults Possible causes Possible solutions
The appliance is
not working.
The mains plug is not
connected.
Connect the appliance to
a mains power socket.
The appliance is not switched on. Switch the appliance on with
the On/Off switch .
The clamps are not secured. Close the clamps .
The motor stops
still while juicing or
it turns noticeably
more slowly or
unevenly.
The filter
3
is blocked.
Switch the juicer off immediately
and pull out the mains plug
.
Remove the blockage (see sec-
tion "Juicing").
The pulp is moist
and you obtain too
little juice.
You are working too fast. Work a little more slowly.
The filter
3
is blocked.
Clean the filter
3
(see section
"Cleaning and Care").