Silvercrest SBT 3.6 A1, Operating Instructions Manual

Page: 14 / 83

11
SBT 3.6 A1
GB
CY
5) Start by combing the eyebrows against the direction of hair growth.
6) Run the precision trimmer
6
with the eyebrow comb
4
from the outer end of the
eyebrow towards the bridge of the nose.
7) When you are fi nished with the treatment, push the on/off switch
w
in the opposite
direction to switch off the appliance.
Using the micro trimmer to form the eyebrows or remove
individual facial hairs
You can use the micro trimmer
7
to form the eyebrows or remove individual facial hairs.
1) Start by removing any other attachment from the hand element
q
, if required.
Fit the micro trimmer
7
on the hand element
q
. The slight curvature of the micro
trimmer
7
must be facing towards the side of the hand element
q
on which the
on/off button
w
is located (see chapter "Fitting/removing the attachments").
2) Push the on/off switch
w
in the direction of the attachment.
3) Move the micro trimmer
7
in a careful and controlled manner. Always move the micro
trimmer
7
against the direction of hair growth. Ensure that the micro trimmer
7
is
always fully in contact with your skin.
4) When you are fi nished with the treatment, push the on/off switch
w
in the opposite
direction to switch off the appliance.
Shaving with the micro shaver
Use the micro shaver
3
to remove short hairs along the contours of your bikini line.
This allows you to keep your bikini line well defi ned.
NOTE
► You should trim longer hairs fi rst with the precision trimmer
6
before you use the
micro shaver
3
.
1) Start by removing any other attachment from the hand element
q
, if required.
Fit the micro shaver
3
on the hand element
q
. The slight curvature of the micro
shaver
3
must be facing towards the side of the hand element
q
on which the
on/off button
w
is located (see chapter "Fitting/removing the attachments").
2) Remove the protective cap
2
.
3) Push the on/off switch
w
in the direction of the attachment.
4) Place the shaving foil gently on the skin and move the appliance against the direction
of hair growth.
5) When you are fi nished with the treatment, push the on/off switch
w
in the opposite
direction to switch off the appliance.
6) Replace the protective cap
2
.