Silvercrest SAS 7.4 LI B1, Operating Instructions Manual

Page: 12 / 75

GB
│
9 ■ SAS 7.4 LI B1
1) Remove the handheld vacuum cleaner from the wall bracket or, if you are
not using the wall bracket remove the barrel plug from the socket.
2) If required, place the appropriate nozzle in the suction opening:
–
the crevice nozzle , to clean narrow and difficult to reach locations.
–
the wet suction nozzle to vacuum up liquids.
NOTE
► After you have vacuumed up liquids, immediately clean the dirt container
-
.
Otherwise, bacteria or mould will build up inside! Ensure that the dust filter
bag
is completely dry before using the appliance again.
3) To switch the appliance on, slide the on/off switch forwards. The charge
indicator lamp lights up green.
4) When you have finished using the appliance, slide the on/off switch to
the rear.
NOTE
► Place the handheld vacuum cleaner in the wall bracket and start the
charging process once the vacuum power has become noticeably weaker
and the charge indicator lamp
flashes green.
Cleaning
To achieve the best results, empty the dirt container
-
and clean the dust filter
after every use.
CAUTION! MATERIAL DAMAGE!
► Do not use aggressive, chemical or abrasive cleaning agents. These could
damage the outer surfaces of the appliance.
1) To open the dirt container
-
, press the release button and remove the
dirt container
-
.
2) Remove the dust filter from the dirt container
-
.
3) Empty the dirt container - .
4) Pull the dust filter bag with its holder out of the dust filter .
5) Rinse the dust filter bag out in cold water and wait until it is completely
dry before reinserting it into the dust filter . Do not dry it with hot air.
6) Reinsert the dust filter into the dirt container - . When doing so, ensure
that the dust filter is seated squarely and that the rubber lip seals the dirt
container - .